DPA500 Dual Element Infrared Detector

Detector installation location
Detector lens should be perpendicular to the direction of the intruder may break in
Installation height – 2.2m
Do not install the detector in outdoor, near air conditioners, heaters and direct sunlight
Installation steps
Open the front cover and remove the board
Drill the cable entry in the back cover and thread the wires
Install the back cover in the appropriate height
Place back the board and tighten with the plastic screw (for the maximum detection range fix the board at "0" on the vertical angle scale)
Connect the wires to the DPA500 as below and close the front cover.
TAMP NC (1-2) – NC Tamper switch terminals +VIN GND (3-4) – DC-IN terminals RLY NC (5-6) - NC Alarm relay terminals